A gear puller is an incredibly handy tool for removal of stuck or small tolerance pulleys or gears. The centre of the bolt on the puller has a pointed centre allowing it to locate in the centre point of the shaft that the gear or pulley is mounted on. With the three outer jaws firmly locked behind the gear or pulley, the bolt on the gear puller can then be tightened allowing the jaws to slowly pull the gear off of the shaft. The ToolPRO 3 Jaw 150mm gear puller is made from incredibly tough drop forged vanadium steel to ensure no breakages or bends occur from the high tension experienced during pulling. This puller has a 6" or 150mm capacity which is large enough for many gears or pulleys found in automotive or mechanical applications.
Manufactured from durable drop forged chrome vanadium steel for superior rigidity and performance under high load
Transposable design enables both internal and external pulling of components to cover a wide range of requirements
Capable of pulling components up to 150mm (6") in diameter, not to be used with an impact wrench