Everyone knows how easy it is to accidently scratch a bumper bar. But did you know how easy it is to fix?
Here's how it's done:
What you'll need
- Primer Filler
- Plastic Adhesion Primer
- Wax & Grease Remover
- Masking Tape
- Safety Googles
- Dust Mask
- Sanding Block
Sand area to be repaired with 240 grit sandpaper, removing a fine layer off the surface.
Clean the sanded area with Septone Wax & Grease Remover.
Prepare the surface with Septone Plastic Adhesion Primer.
Depending on the depth of the scratch, Septone Body Filler may be required.
Apply Septone Plastic Primer Filler in light even coats.
Allow 5 minutes dry time between each coat.
Sand the area again with 800-1200 wet & dry sandpaper & if required reapply Septone Plastic Primer Filler.
Re-clean with Septone Wax & Grease Remover.
Your repair is now ready for application of a coloured basecoat.
Select a basecoat colour matched to your original vehicle paint code & apply as directed on the back of the can.
When selecting a base coat, make sure you check out the "ColorSpec Paint Mixing" services offered in store while you wait!
*Important information* - Click here to read more about our How-To terms and conditions.